Pre-processed data obtained by AFM nano-indentation of MLO-A5 pre-osteocyte cells. The data pre-processing consisted in contact point fitting, tip-sample separation correction and drift correction of raw data, all performed in MATLAB (v2016a).
The experimental methodology and data processing are described in the author's thesis (Chapter 3).
* AFM cantilever preparation Tip-less cantilevers (Windsor Scientific) with nominal spring constant of 0.2 N/m were customised by glueing a silica bead (D = 6 μm, Bangs Laboratories) at the tip extremity.
* AFM set-up A NanoWizard 3 atomic force microscope (JPK Instruments AG) coupled to an Eclipse Ti-S optical inverted microscope (Nikon Instruments) was used for all the experiments. The cells were washed in phosphate buffer solution (PBS) and fresh medium was added. Samples were positioned on the heated sample holder to allow for testing at 37◦C.
Single cells were located through the coupled optical microscope and images of cell shape were recorded for morphological analysis. The cantilever was centred over the location of interest and a grid of 5 points spaced 3 μm within each other was set. Force spectroscopy measurements were obtained on the 5-point grid for 3 times to collect a total of 15 data on each location. The relative set point and the approach velocity were set to 10 nN and 4 μm/s respectively.
University of Sheffield ‘Mechanoreceptors in health and disease’ Network Scholarship
There is no personal data or any that requires ethical approval
The data complies with the institution and funders' policies on access and sharing
Sharing and access restrictions
The data can be shared openly
The file formats are open or commonly used
Methodology, headings and units
There is a readme.txt file describing the methodology, headings and units